FIDDES Ultra Raw Hard Wax Oil

Fiddes Ultra Raw Hard Wax Oil offers a dead flat-matt ‘raw timber’ effect, with minimal colour change.

Formulated to maintain the natural appearance of untreated wood, Ultra Raw Hard Wax Oil retains this lighter tone, counteracting the ‘wet look’ commonly associated with traditional oil, wax or resin based finishes.

Perfect for lighter coloured woods such as Pine, Oak and Maple.

£10.91£74.05 INC. VAT

(Single Coat depending on substrate)
SKU: N/A Category:

Weight N/A
Preparation

Ensure all surfaces are clean, dry, and free from any previous finish. Sand the substrate with a fine 150 grade sanding paper or 150 grit sanding disk, removing all traces of dust.

Application

Ensure all areas to be coated are extremely well ventilated during and after application. Always test on a small area prior to initial application. No primer required. Maximum 2 coats recommended. Apply at room temperature. Fiddes Hard Wax Oil is formulated for application directly, and does not require thinning.

First Coat

Stir contents thoroughly before and during use, and apply in a warm, well ventilated room. Apply evenly using Fiddes Floor Oil Brush or a good quality bristle or synthetic brush, following the direction of the grain. Leave to dry 4-6 hours in warm, dry well ventilated conditions, or preferably overnight.

Second Coat

Apply as first coat. Leave to dry 4-6 hours in warm well ventilated conditions. Clean applicators with White Spirit. When the area is completely dry, a light buff will further enhance sheen level. With the exceptions of White, Belgium Grey and Oak Lightening, a single coat of Tinted Hard Wax Oil is recommended and then finished with Clear Hard Wax Oil.

Renovation

For regular cleaning apply a light spray of Fiddes Wood Surface Cleaner, and area buffed once dry removing any minor blemishes. Periodically, an application of Fiddes Floor Surface Cleaner is recommended in areas subjected to heavy wear. Re application of Fiddes Hard wax oil may be required in certain areas, where staining is apparent. To renovate previous application of Fiddes Hard Wax Oil, lightly sand area with 150 grit sandpaper, and re-apply sparingly.

Coverage

A single application will cover approximately 20-24 square meters per litre,depending on the density of the substrate.

Size

5ml sachet, 250ml, 1lt, 2.5lt

You may also like…